ItirubTransmitter ADC – Ethernet
This device can perform measurements on analog sensors of the type 4~20, 0~10 and transmit the collected data through “Ethernet” communication with MQTT protocol
ItirubTransmitter
It is a versatile device, made up of hardware and software, created to work without interruptions, to serve remote areas and environments of difficult access, simplifying the measurement of sensors, and data transmission through “Ethernet” connections with MQTT protocol.
Measurement
Featuring multiple inputs for sensors, analog 4~20mA, 0~10v and RS485, with proper treatment, the acquired data can be displayed on panels, and is compatible with the main cloud monitoring systems on the market.
Energy consumption
Equipment with low energy consumption, can be powered by an internal battery, recharge can be carried out through small solar panels or (source) DC connected to the device.
Care and Precautions
The ItirubTransmitter is intended for professional use, and must be handled by trained professionals, qualified in the installation, configuration and operation, use only power supplies following the specifications contained in the manual, to power the ItirubTransmitter
Datasheet
| Communication Interface | |
| Description | ItirubTransmitter ADC - Ethernet |
| Pattern | 10BaseT/100BaseTX Ethernet |
| Baud Rate | 10/100Mbit |
| Sercuity | Autenticação usuário e senha |
| Communication Mode |
Cliente |
| Conexion | RJ45 |
| Protocol | MQTT TCP/IP |
| Unique identifier | Mac Address |
| Sensor Interface | |
| Description | Analog |
|
Channels |
4x4~20 mA 4x0~10v 2x4~20 mA e 2x0~10V |
| Loop Power | 24V Max 50mA |
| Conexion | Terminal plug 18P removível |
| Measuring range | 4 a 20mA 0 a 10V |
| Precision | 0.02 |
| Conexion RS485 | 1xRS485 |
| Electrical and Signaling | |
| Leds status | Power, Bateria, Ethernet, Wifi, LoRa e RS485 |
| Power Supply | 5 a 10Vdc |
| Solar Panel | VOC 6, 500mA *Opcional* |
| Internal Battery | Li-lon 3.6Vlts *Opcional* |
| Internal Temperature | Sensor for measuring the internal temperature of the ItirubTransmitter |
| Battery Level | Sensor for measuring the ItirubTransmitter internal battery level |
| Programming Connector | SWD programming connector with 10-pin 1.27mm interface |
| Settings | Micro USB connection for file storage and Firmware configuration. |
Included Itens
| 01 ItirubTransmitter ADC – Ethernet |
| 01 Cabe USB |
| 01 Font 5V |
| 01 Terminal plug removable |
| 01 Fixing Clamp |
